[Radiance-general] importing illuminance contour back to SketchUp?

[Ery Mailing-List]

Thanks Thomas. I will definitely try it. Ecotect I think reports only the
values, it saves it with the extension ".ok", but I will double check.
However, it will fall in the right location on the 3D model, so I think it
is checked against the grid information.


On Thu, Jun 26, 2014 at 4:18 PM, Thomas Bleicher <tbleicher at gmail.com>
wrote:

> Su2rad has that feature but it may be disabled in the official version.
> You just need to remove a few comments in the loader file to get it
> working. In which format does Ecotect report the values? Just values or
> coordinates and values?
>
> Ery Mailing-List <ery.mailinglist at gmail.com> wrote:
>>
>> Folks
>>
>> I have this question for a long time and have asked it to a number of
>> people with a negative answer, and I can't remember if I have asked the
>> forum, but here it goes: is there a way that we can import the illuminance
>> contour back to SketchUp?
>>
>> We use SketchUp as the interface to Radiance, but the missing piece that
>> we missed from Ecotect is the ability to import back the illuminance values
>> on the grid back into the 3D model, so that the contour can be put into the
>> 3D context.
>>
>> Thanks
>>
>> Ery
>>
>> ------------------------------
>>
>> Radiance-general mailing list
>> Radiance-general at radiance-online.org
>> http://www.radiance-online.org/mailman/listinfo/radiance-general
>>
>>
> --
> Sent from my Android phone with K-9 Mail. Please excuse my brevity.
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://www.radiance-online.org/pipermail/radiance-general/attachments/20140626/5a981ca0/attachment.html>