[Radiance-general] Glaze.csh header and input format
Jack de Valpine
jedev at visarc.com
Wed Feb 14 20:53:48 CET 2007
Hi Siritip,
If this is the header file that I posted awhile ago, I think it is ok,
however you may need to add an end-of-line to the file.
-Jack
siritip at umich.edu wrote:
> Dear Radiance Community,
>
> I'm interested in simulating the glazing and I've checked previous
> posts on modeling the glazing.
>
> I was trying to use the glaze.csh with a separate glazing input file
> and as I read from the thread, it seems that glaze.csh is very
> sensitive to a spacing of the input header file. I used the header
> that was posted from the thread but it still prompted me with 'bad
> header'. So, I'm not sure whether it's the header or my input lines
> that didn't work.
>
> I was wondering if someone could share a file with correct spacing
> of header along with sample input lines that would make glaze.csh run
> without error? Thank you very much in advance.
>
> Siritip Harn.
>
> Ph.D. Pre-Candidate
> Taubman College of Architecture and Urban Planning
> University of Michigan
>
> siritip at umich.edu
>
>
>
>
> _______________________________________________
> Radiance-general mailing list
> Radiance-general at radiance-online.org
> http://www.radiance-online.org/mailman/listinfo/radiance-general
>
>
--
# Jack de Valpine
# president
#
# visarc incorporated
# http://www.visarc.com
#
# channeling technology for superior design and construction
More information about the Radiance-general
mailing list