[Radiance-general] dxf2rad

[Tom Young]

On 23 Oct 2007, at 18:15, Rob Guglielmetti wrote:

> That error makes me think you have gcc installed on your machine,  
> but not all of the libraries.  Have you done a full install of Xcode?

no!

>   Make sure that's been done first, then you may also need to run  
> this as root (do you know about the sudo command, which runs things  
> as root?).

ok w root and that sort of stuff

> After it's been compiled (yes, gcc is a compiler so it's not making  
> a script but an actual executable), you will move the binary to / 
> usr/local/bin with all the other Radiance binaries (you would do  
> this with sudo too, i.e. "sudo mv dxfimport /usr/local/bin").  sudo  
> will ask you for the administrative password, which you likely set  
> up when you set up your Mac initially.  Hope this helps (and does  
> not hurt)!

nothing hurts yet

thanks v much

tom


Tom Young Architects
19 Bassett Street
London
NW5 4PG
020 7482 6150
07765 378 502
thdyoung at mac.com
http://homepage.mac.com/thdyoung/FileSharing1.html
http://localstinker.blogspot.com/
http://www.localstink.com/rktat/index.html