--- ray/doc/notes/ReleaseNotes	2021/01/15 23:16:06	1.380
+++ ray/doc/notes/ReleaseNotes	2021/03/12 18:32:33	1.388
@@ -2395,4 +2395,33 @@ Added "test" target to makeall to run unit tests.
 
 Modified bsdf2ttree to allow different parameters per input SIR file.
 
-Fixed issues with very large matrix files (> 2GB) in dctimestep, rmtxop, and rcollate.
+Fixed issues with very large matrix files (> 2GB) in dctimestep, rmtxop,
+and rcollate.
+
+Added -rf and -rb options to rmtxop to load front or back reflectance
+matrix data from XML file rather than transmission.  (Lars Grobe suggested.)
+
+Improved behavior for coincident surfaces with different materials.
+Rather than returning one surface or the other based on floating-point
+vagaries, opaque materials are now preferred over transparent ones.
+If the materials are both transparent or both opaque, then whichever
+surface appeared later in the scene description will be selected.
+This came of a request for consistent behavior with legal CAD output
+from Peter Apian-Bennewitz.
+
+Added explicit tests for on-edge intersections with polygons.  This should
+eliminate stray rays and tiny light leaks that often appear even in
+well-constructed geometry.
+
+Added "-s up" option to pabopto2bsdf to allow for 180 degree symmetry,
+meaning that data repeats after 180 degree rotation (as distinguished
+from "-s bilateral" whose data is mirrored about a vertical plane).
+Thanks to Helen Rose Wilson for the suggestion and informing me that
+such a thing exists.
+
+Removed upper limit on number of modifiers in rcontrib.
+
+Put cap on maximum ambient gradient to avoid over-extrapolation of
+poorly computed irradiance cache values.
+
+Added robjutil +T option to triangulate all faces in .OBJ description.