--- ray/doc/notes/ReleaseNotes	2004/09/10 16:05:07	1.43
+++ ray/doc/notes/ReleaseNotes	2004/09/23 18:00:54	1.49
@@ -1305,3 +1305,28 @@ Fixed rad so that 'scene' variable may consist only of
 Fixed bug introduced in shadow caching routines where sources in the
 middle of spheres were not illuminating properly.  Thanks to Guilio
 Antonutto for spotting this problem.
+
+Modified gensky behavior so if time is given with standard time zone
+designation, any -m option is ignored.
+
+Added -n option to mkillum for (shared memory) parallel processing.
+
+Fixed a long-standing bug in parallel processing code that only
+seemed to manifest with the new mkillum -n option, where rtrace
+would deadlock upon termination.  The reason it never showed up
+before is because I always closed processes in the reverse order
+of opening them in other programs.  I went through and found similar
+(potential) bugs in the rview device subprocess code and util/netproc.c.
+
+Corrected the normalization of the Gaussian reflectance model.  This will
+cause an increase in specularity for low-lying light sources.
+Thanks to Don Walters of Boeing and Arne Duer of the Univ. of Innsbruck
+for pointing out this error.  The square root used for the two cosines
+in the denominator of the normalization factor should not be present.
+This was a serious mistake I made in the original model, which went
+undiscovered (at least to my knowledge) for over a decade.  I think
+Bruce Walter of Cornell may have known about it, but I never heard
+the details of his discovery.
+
+Enabled the -p option for primary conversion without tone-mapping
+in ra_bmp.  Also provides for XYZE input conversion to RGB.