--- ray/doc/notes/ReleaseNotes	2004/09/19 08:42:22	1.46
+++ ray/doc/notes/ReleaseNotes	2004/10/11 10:02:15	1.53
@@ -1256,7 +1256,7 @@ Added -I option to replmarks for mesh instancing.
 Made similar change for virtual sources to allow modifiers and aliases
 on the mirror and prism types to work properly.
 
-Rob Guglielmetti dded -lw and -lh options to falsecolor to control the
+Rob Guglielmetti added -lw and -lh options to falsecolor to control the
 legend dimensions.  Made it so -lw 0 and/or -lh 0 turns legend off.
 
 Made it so pcompos will read everything from a stream even if it doesn't
@@ -1296,7 +1296,7 @@ Fixed a very obscure bug in rpict that caused a dark h
 line in certain cylindrical projections due to improper drawing
 of the sky dome source in rt/srcdraw.c.
 
-Fixed problems with effective ray lenths computed for dielectric
+Fixed problems with effective ray lengths computed for dielectric
 and BRTDfunc materials.  This was most evident in breakup of holodeck
 views when VDISTANCE=True.
 
@@ -1311,6 +1311,33 @@ designation, any -m option is ignored.
 
 Added -n option to mkillum for (shared memory) parallel processing.
 
-Fixed long-standing bug in parallel processing code that only seemed
-to manifest with the new mkillum -n option, where rtrace would
-deadlock upon termination.
+Fixed a long-standing bug in parallel processing code that only
+seemed to manifest with the new mkillum -n option, where rtrace
+would deadlock upon termination.  The reason it never showed up
+before is because I always closed processes in the reverse order
+of opening them in other programs.  I went through and found similar
+(potential) bugs in the rview device subprocess code and util/netproc.c.
+
+Corrected the normalization of the Gaussian reflectance model.  This will
+cause an increase in specularity for low-lying light sources.
+Thanks to Don Walters of Boeing and Arne Duer of the Univ. of Innsbruck
+for pointing out this error.  The square root used for the two cosines
+in the denominator of the normalization factor should not be present.
+This was a serious mistake I made in the original model, which went
+undiscovered (at least to my knowledge) for over a decade.  I think
+Bruce Walter of Cornell may have known about it, but I never heard
+the details of his discovery.
+
+Enabled the -p option for primary conversion without tone-mapping
+in ra_bmp.  Also provides for XYZE input conversion to RGB.
+
+Fixed what I consider a bug in pvalue -o when taking XYZE files on input,
+where it was inappropriately undoing the exposure value so that it always
+reported radiance rather than XYZ values with Y in cd/m^2.
+
+Made it so ra_bmp only produces run-length encoded 8-bit output for
+grayscale images that are tone-mapped.  This minimizes circumstances
+under which output scanline order is reversed.
+
+Fixed bug in rcalc where it sometimes wasn't parsing the input format
+correctly.