[ViewVC] Diff of: radiance/ray/doc/man/man1/rcode

Comparing ray/doc/man/man1/rcode_ident.1 (file contents):
Revision 1.5 by greg, Wed Apr 28 19:15:09 2021 UTC vs.
Revision 1.7 by greg, Wed Aug 24 19:34:07 2022 UTC

#	Line 34 \| Line 34 \| input.txt
34		][
35		.B \-tS
36		]
37	–	[
37		input.idx
38		[output.txt]
40	–	]
39		.SH DESCRIPTION
40		.I Rcode_ident
41		takes a list of ASCII identifiers on the input and encodes them
#	Line 63 \| Line 61 \| and the maximum ID length is 255 characters.
61		.PP
62		Input is taken from the first named file, or standard input if no
63		files are given.
64	+	(Input file is required for
65	+	.I \-r
66	+	option.)
67		Output is sent to the second named file, or standard output if none.
68		.PP
69		The
#	Line 84 \| Line 85 \| The second form applies the
85		.I \-r
86		option to read an indexed id file and produce the original
87		identifiers for each pixel position on the output.
88	+	With this option, the ID file must be given on the
89	+	command line and cannot be read from the standard input.
90		The
91		.I \-h
92		and
#	Line 111 \| Line 114 \| to produce an identifier for each integer input pair s
114		the horizontal and vertical coordinates of a particular pixel,
115		where x is measured from 0 on the left and y from 0 at the bottom
116		in the standard orientation.
114	–	Note that
115	–	.I \-i
116	–	implies that an indexed ID file is explicitly given on the command
117	–	line, since the pixel coordinates are read from the standard input.
117		If the
118		.I \-u
119		option is also given, output will be flushed after each identifier

-–
+Removed lines
-+
+Added lines
-<
+Changed lines
->
+Changed lines